Product description
Practical dosing pen with liquid flux. Ideal for manual tinning and for restoring solderability during e.g. repair work. Gives the tin/solder very good wetting. Works like a felt-tip pen where you press in the tip to make the liquid come out. Excellent for lead-free precision soldering.
The residue has no corrosive effect after soldering, so there is no requirement for cleaning after soldering (the flux is of the No-Clean type). If you however, wish to wash off residues, this is done with isopropanol.
The flux is an alcohol-based solution of rosin with the addition of organic activators, type ISO 9454 (1134 / J-STD-004 ROL0).
Specifications:
- Content: 8 ml
- Soldering temperature (max): 280ºC
- Storage temperature: 5-25ºC
Always read the safety data sheet before use. Use only in a well-ventilated area. Always close the pen with the cap after use. Keep out of reach of children. Do not store near oxidizing substances.
Hazard:
- H225 - Highly flammable liquid and vapour
- H317 - May cause an allergic skin reaction
- H318 - Causes serious eye damage
- H336 - May cause drowsiness or dizziness
- H373 - May cause damage to organs through prolonged or repeated exposure
Precautionary statement:
- P101 - Keep out of reach of children
- P210 - Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.
- P260 - Do not breathe fume/mist/vapours
- P280 - Wear protective gloves and eye protection
- P305+P351+P338 - IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
- P310 - Immediately call a doctor
- P333+P313 - If skin irritation or rash occurs: Get medical advice/attention.
- P370+P378 - In case of fire: Use powder extinguisher/sand/carbon dioxide to extinguish
