Product description
Simply remove the protective backing from the OmniVESA and follow the instructions below to mount your Raspberry Pi either bare or in any of the most popular cases.
The nylon screws provided are long enough to work with all of the relevant cases, though if you find they are protruding too far from the case of your choice you can easily trim them down using some cutting pliers. Just remember to use eye protection when cutting!
The OmniVESA supports 75mm and 100mm spacing mounts
The kit contains
1 x OmniVESA
2 x M4 16mm Nylon Knurled Thumbscrews
2 x 5mm Nylon Spacers
2 x M2.5 x 16 nylon screw
3 x M2.5 nuts
Raspberry Pi uncased - use the nylon bolts provided to attach the Pi to the VESA mount using the mounting holes on the Pi itself
The nylon screws provided are long enough to work with all of the relevant cases, though if you find they are protruding too far from the case of your choice you can easily trim them down using some cutting pliers. Just remember to use eye protection when cutting!
The OmniVESA supports 75mm and 100mm spacing mounts
The kit contains
1 x OmniVESA
2 x M4 16mm Nylon Knurled Thumbscrews
2 x 5mm Nylon Spacers
2 x M2.5 x 16 nylon screw
3 x M2.5 nuts
Raspberry Pi uncased - use the nylon bolts provided to attach the Pi to the VESA mount using the mounting holes on the Pi itself
